Connecting The Ip Phone Kem To An Ip Phone 2002 Or Ip Phone 2004; Procedure 33 - Nortel 2001 Installation And Operation Manual

Figure 17
IP Phone KEM attached to an IP Phone 2002
IP Phone Key Expansion Module (KEM)
The IP Phone KEM connects to the IP Phone 2002 or IP Phone 2004 using
the Accessory Expansion Module (AEM) port on the IP Phone.

Procedure 33

Connecting the IP Phone KEM to an IP Phone 2002 or IP Phone 2004

Use the following instructions to install an IP Phone KEM:
1 Remove the IP Phone from the stand by pressing the IP Phone tilt handle,
and pulling the IP Phone away from the stand.
Note: For the IP Phone 2004, you can also adjust the stand angle to
maximum, instead of removing the stand.
2 Place the connecting arm of the IP Phone KEM behind the IP Phone and
align the IP Phone KEM connection plug to the AEM port on the back of
the IP Phone.
Note: The IP Phones 2002 with the product codes: NTDU76AB34,
NTDU76BB34, NTDU76AB70, and NTDU76BB70 have shorter
connector pins than the other IP Phone 2002. Therefore, the ribbon cable
connector of the IP Phone KEM must be detached from the retaining clip
and pressed manually into the header connector before attaching the IP
Phone KEM.
IP Phones Description, Installation, and Operation
Page 179 of 430