Nortel 2001 Installation And Operation Manual page 324

Page 324 of 430
553-3001-368 Standard 7.00
Nortel IP Audio Conference Phone 2033
TN cc uu
ECHG yes
ITEM cls hfa
ITEM
Note: You must enter HFA for proper set operation. The patch
HFA-MPLR19682 must be loaded and activated before you can enter
HFA.
For more information, see Software Input/Output: Administration
(553-3001-311).
3 Connect one end of the CAT5 Ethernet cable to the network interface
located on the back of the Power Interface Module (PIM). See Figure 64.
Plug the other end of the CAT5 Ethernet cable into your IP network
interface.
Figure 64 shows the Power Interface Module (PIM).
Figure 64
PIM
4 Connect one end of the AC power adapter cord to the power supply port
located on the back of the PIM. Thread the cord through the channel on
the bottom of the PIM and plug the other end into the AC power source.
Ensure the correct AC power transformer is used. The voltage rating of
the transformer must match the wall outlet voltage. Refer to Table 41 on
page 320.
August 2005