Procedure 35
Installing the USB Headset Adapter
1
Connect the coiled lower cord to the headset cord with the Quick
Disconnect connector. Ensure the Quick Disconnect connector is
securely fastened.
2
Connect the headset cord to the RJ9 jack on the adapter.
3
Connect the USB cable to the headset adaptor and to one of the USB
jacks on the back of your PC or USB hub.
The first time the headset adapter is plugged in, there is a delay while
Windows configures the device and locates the appropriate driver
software. During the installation you are prompted to supply the original
Windows CD-ROM so Windows can locate the required drivers.
Installing or upgrading the IP Softphone 2050
There are two options to obtain the latest version of the IP Softphone 2050:
•
new installation — when the IP Softphone 2050 is installed for the first
time
•
upgrade — when the IP Softphone 2050 is already installed on the PC
Note 1: To upgrade on Windows 2000 and Windows XP platforms,
refer to Procedure 37," Upgrading the IP Softphone 2050 on your PC (for
Windows 2000 and Windows XP users only)", on
Note 2: IP Softphone 2050 users on Windows 98, Windows 98SE,
Windows 98ME, and Windows ME cannot use the normal upgrade
version since it is not supported on Windows 98 platforms. Please refer
to Procedure 38," Upgrading the IP Softphone 2050 on your PC (for
Windows 98 platforms)", on
Note 3: Before you upgrade an IP Softphone 2050, record the
information in the Configuration Utility's Server tab (see
information might be required in the future.
Nortel IP Softphone 2050
End of Procedure
page
223.
IP Phones
Description, Installation, and Operation
Page 221 of 430
page
222.
page
235). This