Nortel 2001 Installation And Operation Manual page 118

Page 118 of 430
553-3001-368 Standard 7.00
Nortel IP Phone 2004
5 Power the IP Phone 2004 using either the Power over Ethernet or an AC
power transformer (local power).
a. To use local power, plug the AC power transformer into the nearest
power outlet.
b. Ensure the correct AC power transformer is used. The voltage rating
of the transformer must match the wall outlet voltage. Refer to
Table 12 on
power adapter jack (see Figure 10 on
6 When the Nortel logo appears in the middle of the display, immediately
press the four feature keys at the bottom of the display in sequence from
left to right.
7 At the prompt EAP enable?, select Yes. Enter DeviceID and Password.
For more information on EAP, refer to Appendix C: "802.1x Port-based
network access control" on
Note: If you select No, you will not be prompted to enter Device ID and
Password.
8 At the prompt DHCP Yes/No?, select Yes.
9 Select Partial or Full DHCP.
a. If you select Full DHCP, then the following parameters are retrieved
from the DHCP server:
— a valid IP Phone 2004 IP address
— a subnet mask
— the default Gateway for the IP Phone 2004 on the LAN segment
to which it is connected
— the S1 node IP address of the IP line node
— the S1 Action
— the S1 retry count. This is the number of times the IP Phone
attempts to connect to the server
— the S2 node IP address of the IP line node
— the S2 Action
— the S2 retry count
— the External Application Server (XAS) IP address
August 2005
page 106. Connect the AC power transformer to the
page 361.
page 111).