Changing The Tn Of An Existing Ip Softphone 2050; Procedure 39; Removing An Ip Softphone 2050 From Service - Nortel 2001 Installation And Operation Manual

Page 246 of 430

Changing the TN of an existing IP Softphone 2050

Removing an IP Softphone 2050 from service

553-3001-368 Standard 7.00
Nortel IP Softphone 2050
This procedure is required for a new user of the IP Softphone 2050
application.

Procedure 39

Changing the TN of an existing IP Softphone 2050
1 Exit the IP Softphone 2050 application.
2 Restart the IP Softphone 2050 application.
If the node password is not configured, or is configured but disabled, go
to Step 3.
If the node password is configured and enabled for the node, go to Step 4.
3 During startup, the IP Softphone 2050 registers again with the TPS and
the IP Softphone 2050 displays the existing node number and TN for
approximately five seconds.
4 If the password is configured and enabled for the node, the node number
and password prompt displays for approximately five seconds; enter the
correct password within this five-second period.
If the user activates the Clear soft key during the five-second period, the
existing node and TN are cleared and the user is prompted for new
parameters.
Procedure 40
Removing an IP Softphone 2050 from service
1 Exit the IP Softphone 2050 application.
2 Uninstall the IP Softphone 2050 application from the PC by removing it
through Windows Add/Remove Programs.
3 In LD 11, OUT the TN.
August 2005
End of Procedure
End of Procedure