Nortel 2001 Installation And Operation Manual page 77

Ensure the correct AC power transformer is used. The voltage rating of
the transformer must match the wall outlet voltage. Refer to Table 8 on
page 71. Connect the power jack as shown in Figure 6 on
sure to thread the cord around the retaining hook to provide strain relief
for a secure power connection.
6 When the Nortel logo appears in the middle of the display, immediately
press the four feature keys at the bottom of the display in sequence from
left to right.
7 At the prompt EAP enable?, select Yes. Enter DeviceID and Password.
For more information on EAP, refer to Appendix C: "802.1x Port-based
network access control" on
Note: If you select No, you will not be prompted to enter Device ID and
Password.
8 At the prompt DHCP Yes/No?, select No.
9 Enter the following information provided by your system administrator:
Screen prompt
set IP
net msk
def gw
10 Enter the information for the primary Connect Server (S1) and the
secondary Connect Server (S2):
Screen prompt
S1 IP
S1 Port
S1 action
S1 retry
S2 IP
S2 Port
S2 action
S2 retry
Nortel IP Phone 2002
page 361.
Description
A valid IP Phone 2002 IP address.
A subnet mask.
The default Gateway for the IP Phone 2002 on
the LAN segment to which it is connected.
Description
The node IP address of the IP line node.
This is a fixed value: 4100
This is a fixed value: 1
The number of times the IP Phone 2002
attempts to connect to the server. Enter
10.
Same as S1 in most cases (see note
below).
Same as S1
Same as S1
Same as S1
IP Phones Description, Installation, and Operation
Page 77 of 430
page 76. Be