Ip Phone Kem Startup Initialization - Nortel 2001 Installation And Operation Manual

Page 180 of 430

IP Phone KEM startup initialization

Table 20
Startup initialization process for the IP Phone KEM
Phase
1. IP Phone KEM performs
self-test
553-3001-368 Standard 7.00
IP Phone Key Expansion Module (KEM)
3 Press the IP Phone KEM and IP Phone firmly together until the IP Phone
KEM locks into place.
4 If connecting a second IP Phone KEM, repeat steps 1-3.
Note: The second IP Phone KEM is attached to the right side of the first
IP Phone KEM.
5 Attach the IP Phone stand and the IP Phone KEM stand, if removed.
Adjust each IP Phone KEM stand to the same angle as the IP Phone.
The IP Phone KEM powers up.
Note: The IP Phone KEM uses the electrical connection of the IP Phone
2002 or IP Phone 2004 for power. It does not have its own power source.
Once the IP Phone KEM has been installed and powered up on your
IP Phone 2002 or IP Phone 2004, the IP Phone KEM initializes (see
Table 20).
Description
The self-test confirms the operation of the IP Phone KEM's local
memory, CPU, and other circuitry. While undergoing this
self-test, the IP Phone KEM display lights up.
Note: If the IP Phone KEM display does not light up, or lights
up and then goes blank, or fails to begin flashing, check that the
IP Phone KEM is correctly installed and configured.
August 2005
End of Procedure