Procedure 17; Pre-Installation Checklist - Nortel 2001 Installation And Operation Manual

Table 12
IP Phone 2004 component list (Part 2 of 2)
Power transformer (117/120 VAC 50/60 Hz) (North America)
Power transformer 3 prong AC to AC, direct plug-in, 8W, 240 VAC,
50Hz to 16 VAC at 500 mA (Ireland and UK)
Power transformer AC to AC, direct plug-in, 8W, 230 VAC, 50/60 Hz,
to 16 VAC at 500 mA (Europe)
Power transformer 2 prong wall plug direct plug-in AC to AC, 8W,
240 VAC, 50 Hz, to 16 VAC at 500 mA (Australia and New Zealand)
Power transformer AC to AC, direct plug-in, 8W, 100 VAC, 50 Hz, to
16 VAC at 500 mA
Before you begin
For more information, and for information about previous versions of the IP
Phone, contact Nortel.
The following section provides a step-by-step guide through the
IP Phone 2004 installation process. Before installing the IP Phone 2004,
complete the following pre-installation checklist.

Procedure 17

Pre-installation checklist

1 Ensure there is one IP Phone 2004 boxed package for each IP Phone
2004 being installed. The package contains:
• IP Phone 2004
• Handset
• Handset cord
• Footstand
• 2.3 m (7 foot) Ethernet cable, Category 5
• Getting Started card
2 To install and configure an IP Phone 2004 , the host system must be
installed with the Voice Gateway Media Card.
Nortel IP Phone 2004
IP Phones Description, Installation, and Operation
Page 107 of 430
A0619627
A0656598
A0619635
A0647042
A0828858