Nortel 2001 Installation And Operation Manual page 109

Nortel IP Phone 2004 Page 109 of 430
Static IP address assignment
During the installation, the IP Phone 2004 parameters are entered manually
using the key pad.
Your system administrator provides the following information: IP address,
subnet mask, and default Gateway.
You must also enter the Connect Server parameters including: IP address,
port number, action, and retry count.
Go to Procedure 18, "Installing an IP Phone 2004 for the first time using
manual configuration" on page 110.
Dynamic IP address assignment — Partial DHCP
For a partial DHCP installation, you must provide, through the IP Phone's
key pad, the Connect Server parameters including: IP address, port number,
action, and retry count. Other parameters (IP Phone IP address, subnet mask,
and default Gateway) are retrieved from the DHCP server.
The IP Phone password, node ID and TN must be entered manually from the
key pad.
For more information about DHCP servers, see Converging the Data
Network with VoIP (553-3001-160).
Go to Procedure 19, "Installing an IP Phone 2004 for the first time using
DHCP" on page 116.
Dynamic IP address assignment — Full DHCP
For a full DHCP installation, all parameters (IP Phone IP address, subnet
mask, default Gateway, Connect Server IP address, port number, action, and
retry count) are retrieved from the DHCP server to recognize the
IP Phone 2004.
The IP Phone 2004 password, node ID and TN must be entered manually
from the key pad.
IP Phones Description, Installation, and Operation