Connecting the components of the phone
base locked in position. To avoid damaging your phone,
press the wall-mount lever, located under the base, to
release the stand and pull it away from the phone.
1. Remove the stand cover. Pull upward on the center catch as
indicated in Figure 5, "Removing the stand", on page 32, and remove
the stand cover. The cable routing tracks are now accessible.
CAUTION
Damage to Equipment
Do not plug your IP Phone 1150E into a regular
telephone jack. This results in severe damage
to the IP Phone. Consult your system
administrator to ensure that you plug your
telephone into a 10/100BaseT Ethernet jack.
Your IP Phone 1150E is designed for use in an
indoor environment only.
Your IP Phone 1150E is shipped with the