Nortel 2001 Installation And Operation Manual page 117

3 Connect the IP Phone 2004 components:
a. Connect one end of the handset cord to the handset jack on the back
of the IP Phone (identified with a handset icon).
b. Connect the other end of the handset cord to the handset.
4 Choose one of the following connections:
a. For an IP Phone not sharing a LAN access with a PC:
Connect one end of the CAT5 Ethernet cable to the LAN ethernet
port located on the back of the IP Phone (identified with a LAN icon).
The other end of the CAT5 Ethernet cable plugs into the IP network.
b. For an IP Phone sharing a LAN access with a PC:
Connect one end of the CAT5 Ethernet cable to the LAN Ethernet
port located on the back of the IP Phone (identified with a LAN icon,
see Figure 10 on
Insert one end of a second CAT5 Ethernet cable into the PC Ethernet
port located on the back of the IP Phone (identified with a PC icon,
see Figure 10 on
CAUTION
Damage to Equipment
Do not plug your IP Phone 2004 into any port but the
PC Ethernet port. Severe damage can result. Consult
your system administrator to ensure that you are
plugging your IP Phone into the PC Ethernet port.
Timing information
There are only four seconds between plugging in the IP Phone 2004
power transformer and the appearance of the Nortel logo in the middle
of the display. When you see the logo, you have one-second to respond
by pressing the four feature keys at the bottom of the display in
sequence from left to right. If you miss the one second response time,
the IP Phone 2004 attempts to locate the connect server. Wait until it is
finished, and then begin the power-up sequence again.
Nortel IP Phone 2004
page 111) and the other end to the IP network.
page 111) and the other end into the computer.
IMPORTANT!
IP Phones Description, Installation, and Operation
Page 117 of 430