Nortel 2001 Installation And Operation Manual page 83

a. To use local power, plug the AC power transformer into the nearest
power outlet.
b. Ensure the correct AC power transformer is used. The voltage rating
of the transformer must match the wall outlet voltage. Refer to Table
8 on page 71. Connect the power jack as shown in Figure 6 on
page 76. Be sure to thread the cord around the retaining hook to
provide strain relief for a secure power connection.
6 When the Nortel logo appears in the middle of the display, immediately
press the four feature keys at the bottom of the display in sequence from
left to right.
7 At the prompt EAP enable?, select Yes. Enter DeviceID and Password.
For more information on EAP, refer to Appendix C: "802.1x Port-based
network access control" on
Note: If you select No, you will not be prompted to enter Device ID and
Password.
8 At the prompt DHCP Yes/No?, select Yes.
9 Select Partial or Full DHCP.
a. If you select Full DHCP, then the following parameters are retrieved
from the DHCP server:
— a valid IP Phone 2002 IP address
— a subnet mask
— the default Gateway for the IP Phone 2002 on the LAN segment
to which it is connected
— the S1 node IP address of the IP line node
— the S1 action
— the S1 retry count (This is the number of times the IP Phone
attempts to connect to the server.)
— the S2 node IP address of the IP line node
— the S2 action
— the S2 retry count
— the External Application Server (XAS) IP address
Nortel IP Phone 2002
page 361.
IP Phones Description, Installation, and Operation
Page 83 of 430