Page 122 of 430
Startup sequence
553-3001-368
Standard 7.00
Nortel IP Phone 2004
10 Enter the following information provided by your system administrator.
Screen prompt
Password
Node
TN
The IP Phone 2004 registers with the TPS and, if needed, will begin the
firmware download. This takes several minutes. When the download is
complete, the IP Phone 2004 resets.
Note: The Enhanced UNIStim Firmware Download feature for IP Phones
provides an improved method of delivering new firmware to IP Phones.
For further information on Enhanced UNIStim Firmware Download, refer
to IP Line: Description, Installation, and Operation (553-3001-365).
The current system date and time appear on the top line of the display
when the configuration is complete. Self-labeling keys also appear.
11 Check for dial tone and the correct DN above the display.
12 Secure the IP Phone footstand to the base of the IP Phone. Use the angle
adjustment grip on the top back of the IP Phone to adjust the position.
13 (Optional) Customize the feature keys as required. For more information,
see IP Phone 2004 User Guide.
When an IP Phone 2004 is connected to the network, it must perform a startup
sequence. The elements of the startup sequence include:
•
obtaining the IP parameters
•
finding a default Gateway server
•
authenticating the user
August 2005
Description
IP Phone Installer Password
You are not prompted to enter the IP Phone
Installer Password if it has not been
configured in your system.
The node ID
The TN or VTN
End of Procedure