Nortel 2001 Installation And Operation Manual page 150

Page 150 of 430
First-time installation
IP address assignments
553-3001-368 Standard 7.00
Nortel IP Phone 2007
To install and configure an IP Phone 2007, you must first install a Voice
Gateway Media Card in the system.
CAUTION
Damage to Equipment
Do not plug your IP Phone 2007 into an ISDN
connection. Severe damage can result. Consult your
system administrator to ensure that you are plugging
your IP Phone into a 10/100BaseT Ethernet jack.
During the first-time installation, there are IP address parameters that are
entered either manually or automatically depending on the installation
configuration. As well, you are prompted to enable or disable 802.1Q VLAN.
For more information, see "802.1Q VLAN description" on
There are three configuration modes which you can choose from to obtain the
IP parameters. Review the following sections for more information on the
configuration mode you are using.
Static IP address assignment
During the installation, the IP Phone 2007 parameters are entered manually
using the dialpad.
Your system administrator provides the following information: IP address,
subnet mask, and default Gateway.
You must also enter the Connect Server parameters including: IP address,
port number, action, and retry count.
Go to Procedure 26, "Installing an IP Phone 2007 for the first time using
manual configuration" on
August 2005
page 151.
page 353.