Nortel 2001 Installation And Operation Manual page 370

Page 370 of 430
553-3001-368 Standard 7.00
Appendix D: IP Phone diagnostic utilities
IP Networking statistics
In Local or Remote Mode, the system administrator can view information on
the packets sent, packets received, broadcast packets received, multicast
packets received, incoming packets discarded, and outgoing packets
discarded.
DHCP information process
In Remote Mode, the system administrator can view DHCP settings (for
example, IP address, S1, S2, and S4 addresses) for each IP Phone. In Local
Mode partial information is available.
UNIStim/RUDP statistics
In Remote Mode, the system administrator can view RUDP statistics (for
example, number of messages sent, received, retries, resets, and uptime) for
the IP Phones.
RTP/RTCP statistics
In Remote Mode, the system administrator can view RTP/RTCP QoS metrics
(for example, packet loss and jitter) while a call is in progress.
Network QoS Process
In Remote Mode, the system administrator can view QoS statistics (for
example, packets sent, packets received, packet loss, jitter average and jitter
maximum, and round trip delay).
Supplicant Status
The system administrator uses this option to determine whether 802.1x is
enabled or disabled 802.1x.
Authentication State
The system administrator uses this option to determine whether the IP Phone
is currently authenticated with the 802.1x system. The following are valid
state values:
• LogOff
• Disconnected
August 2005