Nortel 2001 Installation And Operation Manual page 164

Page 164 of 430
553-3001-368 Standard 7.00
Nortel IP Phone 2007
Duplex (0-Auto, 1-Full):0
GARP Ignore? (0-No,1-Yes)
Note: The IP Phone 2007 can support a primary (S1) and secondary
(S2) connect server. If you require IP Phones to register on multiple
nodes, refer to "Enhanced Redundancy for IP Line Nodes" in IP Line:
Description, Installation, and Operation (553-3001-365).
The IP Phone 2007 searches for the connect server. When the
connection is complete, proceed to step 9.
9 Enter the following information provided by your system administrator.
Note: When entering the IP addresses and subnet mask, use the star (*)
key on the dialpad to represent the dot (.).
Screen prompt
Password
Node
TN
The IP Phone 2007 registers with the TPS and, if needed, begins the
firmware download. This takes several minutes. When the download is
complete, the IP Phone 2007 resets.
Note: The Enhanced UNIStim Firmware Download feature for IP Phones
provides an improved method of delivering new firmware to IP Phones.
For further information on Enhanced UNIStim Firmware Download, refer
to IP Line: Description, Installation, and Operation (553-3001-365).
10 Check for dial tone and the correct DN above the display.
11 Secure the IP Phone footstand to the base of the IP Phone. Use the angle
adjustment grip on the top back of the IP Phone to adjust the position.
12 (Optional) Customize the feature keys as required. For more information,
see IP Phone 2007 User Guide.
13 Tap the Tools icon to calibrate the touch panel and stylus.
14 Tap the Touch Panel Setup soft key.
August 2005
Default 0 (for Auto)
Default 0 (for No)
Description
IP Phone Installer Password
You are not prompted to enter the IP Phone
Installer Password if it has not been
configured in your system.
the node ID
the TN or VTN