Procedure 12; Disabling Auto Negotiate And Enabling Full Duplex; Mode; Checking Ethernet Statistics - Nortel 2001 Installation And Operation Manual

Procedure 12

Disabling Auto Negotiate and enabling Full Duplex

mode

1 Reset the phone by disconnecting and reconnecting power.
2 When the Nortel logo appears in the middle of the display, press each of
the soft keys in sequence. See Procedure 10 on
3 If no other configuration changes are required, press the OK soft key
repeatedly until the Duplex network option appears.
4 Select 1 to enable Full Duplex mode.
5 When the Speed option appears, select one of the following:
• 0 for 10 Mbps
• 1 for 100 Mbps (default)
6 Select OK to confirm the change.
7 Restart the IP Phone. The firmware reads the new setting, and the
IP Phone operates in Full Duplex mode.
When the IP Phone is restarted, the firmware reads the setting for Full
Duplex mode and sets both port 0, network interface port, and port 1, PC
interface port, accordingly.
Use the following procedure to confirm activation of Full Duplex mode.
Procedure 13

Checking Ethernet Statistics

1 Double-click the Services key. The Network Diagnostics menu appears.
2 Select Ethernet Statistics.
• If Full Duplex mode is active, the following is displayed:
— Link: UP
— Duplex: Full
— Speed: 10 (Mb) or 100(Mb)
— Auto-Nego Capability: N
— Auto-Nego Completed: N
Nortel IP Phone 2002
End of Procedure
IP Phones Description, Installation, and Operation
Page 89 of 430
page 75.