Procedure 11; Installing An Ip Phone 2001 For The First Time; Using Dhcp - Nortel 2001 Installation And Operation Manual

Page 80 of 430 Nortel IP Phone 2002
553-3001-368 Standard 7.00
11 Enter the following information provided by your system administrator:
Screen prompt
Password
Node
TN
The IP Phone 2002 registers with the Terminal Proxy Server (TPS) and,
if needed, begins the firmware download. This takes several minutes.
When download is complete, the IP Phone 2002 resets.
Note: The Enhanced UNIStim Firmware Download feature for IP Phones
provides an improved method of delivering new firmware to IP Phones.
For further information on Enhanced UNIStim Firmware Download, refer
to IP Line: Description, Installation, and Operation (553-3001-365).
The current system date and time appear on the top line of the display
when the configuration is complete. Self-labeling keys also appear.
12 Check for dial tone and the correct DN above the display.
13 Secure the IP Phone footstand to the base of the IP Phone. Use the angle
adjustment grip on the top back of the IP Phone to adjust the position.
14 (Optional) Customize the feature keys as required. For more information,
see IP Phone 2002 User Guide.

Procedure 11

Installing an IP Phone 2002 for the first time

using DHCP

1 Configure a virtual loop on the system using LD 97.
For more information, see Software Input/Output: Administration
(553-3001-311).
2 Configure the IP Phone 2002 on the system using LD 11.
For more information, see Software Input/Output: Administration
(553-3001-311).
August 2005
Description
IP Phone Installer Password
You are not prompted to enter the IP Phone
Installer Password if it has not been configured
in your system.
The node ID.
The TN or VTN.
End of Procedure