Nortel 2001 Installation And Operation Manual page 48

Page 48 of 430 Nortel IP Phone 2001
553-3001-368 Standard 7.00
5 Power the IP Phone 2001 using either the Power over Ethernet or an AC
power transformer (local power).
To use local power, plug the AC power transformer into the nearest
power outlet. Ensure the correct AC power transformer is used. The
voltage rating of the transformer must match the wall outlet voltage.
Refer to Table 4 on page 37. Connect the transformer to the AC power
jack shown in Figure 3 on
the retaining hook to provide strain relief for a secure power
connection.
Timing information
There are only four seconds between plugging in the IP Phone 2001
power transformer and the appearance of the Nortel logo in the middle
of the display area. When you see the logo, you have one second to
respond by pressing the four feature keys at the bottom of the display in
sequence from left to right. If you miss the one-second response time,
the IP Phone 2001 attempts to locate the connect server. Wait until it is
finished, and then begin the power-up sequence again.
6 When the Nortel logo appears in the middle of the display area,
immediately press the four feature keys at the bottom of the display in
sequence from left to right.
7 At the prompt EAP enable?, select Yes. Enter DeviceID and Password.
For more information on EAP, refer to Appendix C: "802.1x Port-based
network access control" on
Note: If you select No, you will not be prompted to enter Device ID and
Password.
8 At the prompt DHCP Yes/No?, select Yes.
9 Select Partial or Full DHCP.
a. If you select Full DHCP, then the following parameters are retrieved
from the DHCP server:
— a valid IP Phone 2001 IP address
— a subnet mask
August 2005
page 42. Be sure to thread the cord around
IMPORTANT!
page 361.