Nortel 2001 Installation And Operation Manual page 169

Procedure 30
Changing the TN of an existing IP Phone 2007
1 Repower the IP Phone 2007.
Note: During the reboot sequence of a previously configured IP Phone,
the IP Phone 2007 displays the existing node number for approximately
five seconds.
2 If node password is enabled and NULL, choose one of the following:
a. Disable password.
b. Set password as non-NULL.
3 Press OK when the node number displays.
If
node password is enabled and is
not NULL
node password is disabled
4 Enter password at the password screen, and press OK.
A TN screen displays.
5 Select the Clear soft key to clear the existing TN.
Nortel IP Phone 2007
Then
a password screen displays. Go to
step 4.
a TN screen displays. Go to
step 5.
IP Phones Description, Installation, and Operation
Page 169 of 430