Procedure 25; Pre-Installation Checklist - Nortel 2001 Installation And Operation Manual

Procedure 25

Pre-installation checklist

1 Ensure there is one IP Phone 2007 boxed package for each IP Phone
2007 being installed. The package contains:
• IP Phone 2007
• Handset
• Handset cord
• Footstand
• 7 ft. (2.3 m) CAT5 Ethernet cable
• Getting Started card
2 To install and configure an IP Phone 2007, the host system must be
installed with the Voice Gateway Media Card.
3 If you are not using Power over Ethernet (PoE) you must use the Global
power adapter or your phone will fail to operate. Refer to
page 147
.
WARNING
If you are using local power, you must use the Global
power adapter or your phone will fail to operate.
4 Understand the three configuration modes that you can choose from as
you proceed through the installation of the IP Phone 2007. The three
configuration modes are:
• Static IP address
• Dynamic Partial DHCP – see "Dynamic IP address assignment —
Partial DHCP" on
• Dynamic Full DHCP
DHCP" on
5 A DHCP server and DHCP relay agents, if required, must also be
installed, configured, and running.
Nortel IP Phone 2007
–
see "Static IP address assignment" on
page 151.
–
see "Dynamic IP address assignment — Full
page 151.
End of Procedure
IP Phones Description, Installation, and Operation
Page 149 of 430
Table 17 on
page 150.