Introduction; Description - Nortel 2001 Installation And Operation Manual

Page 60 of 430 Nortel IP Phone 2002

Introduction

Description

553-3001-368 Standard 7.00
This section explains how to install and maintain the IP Phone 2002. For
information on using the IP Phone 2002, see the IP Phone 2002 User Guide.
This section contains the following procedures:
• Procedure 9, "Pre-installation checklist" on
• Procedure 10, "Installing an IP Phone 2002 for the first time using
manual configuration" on
• Procedure 11, "Installing an IP Phone 2002 for the first time using
DHCP" on page
• Procedure 12, "Disabling Auto Negotiate and enabling Full Duplex
mode" on page
• Procedure 13, "Checking Ethernet Statistics" on
• Procedure 14, "Changing the TN of an existing IP Phone 2002" on
page 90.
• Procedure 15, "Replacing an IP Phone 2002" on
• Procedure 16, "Removing an IP Phone 2002 from service" on
Note: After an IP Phone has been installed and configured, if power is
to the phone is interrupted, re-entry of the IP parameters, Node Number,
TN, or re-acquisition of firmware is not required.
The IP Phone 2002 brings voice and data to the desktop environment. It
connects directly to the LAN through the Ethernet connection.
The IP Phone 2002 components are shown in Figure 4 on
August 2005
page 75.
80.
89.
page 72.
page 89.
page 91.
page
page 61.
92.