Before You Begin; Connecting The Components Of The Phone - Nortel 1150E User Manual

Connecting the components

Before you begin

Connecting the components of the phone

WARNING Your IP Phone 1150E is shipped with the
base locked in position. To avoid damaging your phone,
press the wall-mount lever, located just under the
Handsfree key as indicated in Figure 7 on page 34, to
release the base and pull it away from the phone.
Author's note:
The above warning needs to be updated because the 1150E is
a different form factor than the 1140E. The description for connecting the
components needs to be modified for the 1150E. This will include new graphics.
1. Remove the stand cover. Pull upward on the center catch as
indicated in Figure 5, and remove the stand cover. The cable routing
tracks are now accessible.
CAUTION
Damage to Equipment
Do not plug your IP Phone 1150E into a
regular telephone jack. This results in severe
damage to the IP Phone. Consult your system
administrator to ensure that you plug your
telephone into a 10/100BaseT Ethernet jack.
CAUTION
Your IP Phone 1150E is designed for use in an
indoor environment only.
30