Vlan Commands - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
Use virtual LAN (VLAN) commands to configure and manage parameters for individual port
VLANs on network ports. This chapter presents VLAN commands alphabetically.
clear fdb
Deletes an entry from the forwarding database (FDB).
Syntax: clear fdb {perm | static | dynamic | port port-list} [vlan vlan-id] [tag tag-value]
perm
static
dynamic
port port-list Clears dynamic entries that match destination ports in the port list. You are not
vlan vlan-id VLAN name or number - required for removing permanent and static entries.
tag tag-value VLAN tag value that identifies a virtual port. If you do not specify a tag value,
Defaults: None
Access: Enabled
Usage: You can delete forwarding database entries based on entry type, port, or VLAN. A
VLAN name or number is required for deleting permanent or static entries.
D-Link Systems, Inc.

VLAN Commands

Clears permanent entries. A permanent entry does not age out and remains in
the database even after a reboot, reset, or power cycle. You must specify a
VLAN name or number with this option.
Clears static entries. A static entry does not age out, but is removed from the
database after a reboot, reset, or power cycle. You must specify a VLAN name
or number with this option.
Clears dynamic entries. A dynamic entry is automatically removed through
aging or after a reboot, reset, or power cycle. You are not required to specify a
VLAN name or number with this option.
required to specify a VLAN name or number with this option.
For dynamic entries, specifying a VLAN removes entries that match only that
VLAN. Otherwise, dynamic entries that match all VLANs are removed.
MSS deletes only entries that match untagged interfaces. Specifying a tag
value deletes entries that match only the specified tagged interface.
VLAN Commands
44