D-Link DWS-1008 Cli Reference Manual page 358

DWS-1008 CLI Reference Guide
Defaults: If you do not specify a filename, MSS uses the same configuration filename that
Access: Enabled.
Usage: This command completely replaces the running configuration with the
configuration in the file.
Examples: The following command reloads the configuration from the most recently
DWS-1008# load config
Reloading configuration may result in lost of connectivity, do you wish to continue? (y/n)
[n]y
success: Configuration reloaded
The following command loads configuration file testconfig1:
DWS-1008# load config testconfig1
Reloading configuration may result in lost of connectivity, do you wish to continue? (y/n)
[n]y
success: Configuration reloaded
mkdir
Creates a new subdirectory in nonvolatile storage.
Syntax: mkdir [subdirname]
subdirname
Defaults: None.
Access: Enabled.
Examples: The following commands create a subdirectory called corp2 and display the
DWS-1008# mkdir corp2
success: change accepted.
D-Link Systems, Inc.
was used for the previous configuration load. For example, if the switch used
configuration for the most recent configuration load, MSS uses configuration
again unless you specify a different filename. To display the filename of the
configuration file MSS loaded during the last reboot, use the show boot
command.
loaded configuration file:
Subdirectory name. Specify between 1 and 32
alphanumeric characters, with no spaces.
root directory to verify the result:
File Management Commands
357