D-Link DWS-1008 Cli Reference Manual page 274

DWS-1008 CLI Reference Guide
Syntax: commit security acl {acl-name | all}
acl-name
all
Defaults: None
Access: Enabled
Usage: Use the commit security acl command to save security ACLs into, or delete them from,
the permanent configuration. Until you commit the creation or deletion of a security
ACL, it is stored in an edit buffer and is not enforced. After you commit a security ACL,
it is removed from the edit buffer.
A single commit security acl all command commits the creation and/or deletion of whatever
show security acl info all editbuffer shows to be currently stored in the edit buffer.
Examples: The following commands commit all the security ACLs in the edit buffer to the
DWS-1008# commit security acl all
configuration accepted
DWS-1008# show security acl
ACL table
ACL table
----------------------------------------------------------
ACL
----------------------------------------------------------
acl_123
acl_124
DWS-1008# show security acl info all editbuffer
acl editbuffer information for all
hit-sample-rate
Specifies the time interval, in seconds, at which the packet counter for each security ACL is
sampled for display. The counter counts the number of packets filtered by the security ACL - or
"hits."
D-Link Systems, Inc.
Name of an existing security ACL to clear. ACL names start with a
letter and are case-insensitive.
Commits all security ACLs in the edit buffer.
configuration, display a summary of the committed ACLs, and show that the edit
buffer has been cleared:
Type Class
IP Static
IP Static
Mapping
Security ACL Commands
273