Set Spantree Backbonefast - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
vlan vlan-id
port port-list
vlan-id
Defaults: Disabled.
Access: Enabled.
Examples: The following command enables STP on all VLANs configured on a switch:
DWS-1008# set spantree enable
success: change accepted.
The following command disables STP on VLAN burgundy:
DWS-1008# set spantree disable vlan burgundy
success: change accepted.

set spantree backbonefast

Enables or disables STP backbone fast convergence on a switch. This feature accelerates
a port's recovery following the failure of an indirect link.
Syntax:
enable
disable
Defaults:
Access:
Usage: If you plan to use the backbone fast convergence feature, you must enable it
on all the bridges in the spanning tree.
Examples: The following command enables backbone fast convergence:
DWS-1008# set spantree backbonefast enable
success: change accepted.
D-Link Systems, Inc.
VLAN name or number. MSS enables or disables
STP on only the specified VLAN, on all ports
within the VLAN.
Port number or list and the VLAN the ports are
in. MSS enables or disables STP on only the
specified ports, within the specified VLAN.
set spantree backbonefast {enable | disable}
Enables backbone fast convergence.
Disables backbone fast convergence.
STP backbone fast path convergence is disabled by default.
Enabled.
STP Commands
233