D-Link DWS-1008 Cli Reference Manual page 284

DWS-1008 CLI Reference Guide
Access: Enabled
Usage: For MSS to count hits for a security ACL, you must specify hits in the set security
acl commands that define ACE rules for the ACL.
Examples To display the security ACL hits on a switch, type the following command:
DWS-1008# show security acl hits
ACL hit-counters
Index
-----------------------------------------------------
1
2
3
show security acl info
Displays the contents of a specified security ACL or all security ACLs that are committed -
saved in the running configuration and nonvolatile storage - or the contents of security ACLs in
the edit buffer before they are committed.
Syntax: show security acl info {acl-name | all} [editbuffer]
acl-name
all
editbuffer
Defaults: None
Access: Enabled
Examples: To display the contents of all security ACLs committed on a switch, type the
DWS-1008# show security acl info all
ACL information for all
D-Link Systems, Inc.
Counter ACL-name
0 acl_2
0 acl_175
916 acl_123
Name of an existing security ACL to display. ACL names must start
with a letter and are case-insensitive.
Displays the contents of all security ACLs.
Displays the contents of the specified security ACL or all security
ACLs that are stored in the edit buffer after being created with set
security acl. If you do not use this parameter, only committed ACLs
are shown.
following command:
Security ACL Commands
283