D-Link DWS-1008 Cli Reference Manual page 228

DWS-1008 CLI Reference Guide
Client Backoff Timer
-----------------------------------------------------------------------------------------------------------------------
Channel Holddown
-----------------------------------------------------------------------------------------------------------------------
Service profiles
show service-profile
Displays service profile information.
Syntax:
name
Defaults:
Access:
Examples:
DWS-1008# show service-profile wpa_clients
ssid-name:
beacon:
WEP Key 1 value: <none>
WEP Key 3 value: <none>
WEP Unicast Index: 1
Shared Key Auth: NO
WPA enabled:
ciphers: cipher-tkip
authentication: 802.1X
TKIP countermeasures time: 60000ms
The table below describes the fields in this display.
D-Link Systems, Inc.
Interval, in minutes, at which radios in a radio profile reduce power
after temporarily increasing the power to maintain the minimum
data rate for an associated client. At the end of each power-backoff
interval, radios that temporarily increased their power reduce it by 1
dBm. The power backoff continues in 1 dBm increments after each
interval until the power returns to expected setting.
Minimum number of seconds a radio in a radio profile must remain
at its current channel assignment before RF Auto-Tuning can
change the channel.
Service profiles mapped to this radio profile. Each service profile
contains an SSID and encryption information for that SSID.
Note: When you upgrade from 2.x, MSS creates a default-dot1x
service profile for encrypted SSIDs and a default-clear service
profile for unencrypted SSIDs. These default service profiles contain
the default encryption settings for crypto SSIDs and clear SSIDs,
respectively.
show service-profile {name | ?}
Displays information about the named service profile. ? Displays a list of
service profiles.
None.
Enabled.
The following command displays information for service profile wpa_clients:
dlink ssid-type:
yes
crypto
auth-fallthru: last-resort
WEP Key 2 value:
WEP Key 4 value:
WEP Multicast Index: 1
Access Point Commands
<none>
<none>
227