Show Snmp Status - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide

show snmp status

Displays SNMP version and status information.
Syntax: show snmp status
Defaults: None
Access: Enabled
Examples: To display SNMP version and status information, use the following command:
DWS-1008# show snmp status
Server:
SNMP agent (server) is enabled
SNMPv1 is enabled
SNMPv2c is disabled
SNMPv3/USM is disabled
SNMP minimum security is unsecured
System name: pubs
System location: -- not set --
System contact: -- not set --
SNMP engine ID: 00000063000000a1c0a80142 (IP 192.168.1.66:161)
SNMP engine boots: 1
SNMP engine time: 19410
SNMP max message size: 2048
The table below describes the fields in this display.
Field
SNMP agent (server) is
SNMPv1 is ...
SNMPv2c is ...
SNMPv3 is ...
D-Link Systems, Inc.
Description
State of the SNMP service on the switch:
• Enabled
• Disabled
State of each supported protocol version of SNMP:
• Enabled
• Disabled
IP Services Commands
110