Access Commands - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
Use access commands to control access to the Mobility Software System (MSS) (CLI).
This chapter presents access commands alphabetically. Use the following table to locate
commands in this chapter based on their use.
disable
Changes the CLI session from enabled mode to restricted access.
Syntax:
Defaults:
Access:
Examples: The following command restricts access to the CLI for the current session:
DWS-1008# disable
DWS-1008>
enable
Places the CLI session in enabled mode, which provides access to all commands required
for configuring and monitoring the system.
Syntax:
Access:
Usage: MSS displays a password prompt to challenge you with the enable password. To
enable a session, your or another administrator must have configured the enable
password to this switch with the set enablepass command.
Examples: The following command plus the enable password provides enabled access to the
DWS-1008> enable
Enter password: password
DWS-1008#
D-Link Systems, Inc.

Access Commands

disable
None.
Enabled.
enable
All
CLI for the current sessions:
Access Commands
10