Set Port Negotiation; Set Port Poe - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide

set port negotiation

Disables or reenables autonegotiation on gigabit Ethernet or 10/100 Ethernet ports.
Syntax: set port negotiation port-list {enable | disable}
port-list
enable
disable
Defaults: Autonegotiation is enabled on all Ethernet ports by default.
Access Enabled
Usage: DWS-1008 10/100 Ethernet ports support half-duplex and full-duplex operation.
Examples: The following command disables autonegotiation on ports 1, 3, and 4 through 7:
DWS-1008# set port negotiation 1,3,4-7 disable
The following command enables autonegotiation on port 6:
DWS-1008# set port negotiation 6 enable

set port poe

Enables or disables Power over Ethernet (PoE) on ports connected to DWL-8220AP access
points.
Caution: When you set the port type for AP use, you can enable PoE on the port. Use the
switch's PoE to power D-Link DWL-8220AP access points only. If you enable PoE on ports
connected to other devices, damage can result and the warranty will be void.
Syntax set port poe port-list enable | disable
port-list
enable
disable
D-Link Systems, Inc.
List of physical ports. MSS disables or reenables autonegotiation on all the
specified ports.
Enables autonegotiation on the specified ports.
Disables autonegotiation on the specified ports.
List of physical ports. MSS disables or reenables PoE on all the specified
ports.
Enables PoE on the specified ports.
Disables PoE on the specified ports.
Port Commands
34