D-Link DWS-1008 Cli Reference Manual page 201

DWS-1008 CLI Reference Guide
Examples:
DWS-1008# set service-profile sp3 psk-raw c25d3fe4483e867d1df96eaacdf8b02451fa
0836162e758100f5f6b87965e59d
success: change accepted.
set service-profile rsn-ie
Enables the Robust Security Network (RSN) Information Element (IE).
set service-profile shared-key-auth
Enables shared-key authentication, in a service profile.
Note: Use this command only if advised to do so by D-Link. This command does not enable
preshared key (PSK) authentication for Wi-Fi Protected Access (WPA). To enable PSK
encryption for WPA, use the set service-profile auth-psk command.
Syntax:
name
enable
disable
Defaults:
Access:
Examples:
DWS-1008# set service-profile sp4 shared-key-auth enable
success: change accepted.
D-Link Systems, Inc.
configuration. The binary number is never displayed in the configuration.
To use PSK authentication, you must enable it and you also must enable the
WPA IE.
The following command configures service profile sp3 to use a raw PSK with
PSK clients:
set service-profile name shared-key-auth {enable | disable}
Service profile name.
Enables shared-key authentication.
Disables shared-key authentication.
Shared-key authentication is disabled by default.
Enabled.
The following command enables shared-key authentication in service profile sp4:
Access Point Commands
200