D-Link DWS-1008 Cli Reference Manual page 392

DWS-1008 CLI Reference Guide
Examples: The following command enters the configuration mode for the currently active
boot> change
Changing the default configuration is not recommended.
Are you sure that you want to proceed? (y/n)
BOOT TYPE: [c]
DEVICE:
FILENAME: [default]
FLAGS:
OPTIONS:
create
Creates a new boot profile.
Syntax: create
Defaults: The new boot profile has the same settings as the currently active boot profile by
Access: Boot prompt.
Usage: A DWS-1008 switch can have up to four boot profiles. The boot profiles are stored
in slots, numbered 0 through 3. When you create a new profile, the system uses the
next available slot for the profile. If all four slots already contain profiles and you try
to create a fifth profile, the switch displays a message advising you to change one
of the existing profiles instead.
To make a new boot profile the currently active boot profile, use the next command. To
change boot parameter settings, use the change command.
Examples: The following command creates a new boot profile in slot 1 on a switch that
boot> create
BOOT Index: 1
BOOT TYPE:
DEVICE:
FILENAME:
FLAGS:
OPTIONS:
D-Link Systems, Inc.
boot profile, changes the device to boot1, and leaves the other parameters with
their current settings:
[boot0:]boot1
[0x00000000]
[run=nos;boot=0]
default.
currently has only one boot profile, in slot 0:
c
boot1:
default
00000000
run=nos;boot=0
Boot Prompt Commands
391