D-Link DWS-1008 Cli Reference Manual page 342

DWS-1008 CLI Reference Guide
AP or client vendors that are allowed on the network. MSS does not list a device as a rogue
or interfering device if the device's OUI is in the permitted vendor list.
Syntax: set rfdetect vendor-list {client | ap} mac-addr
client | ap
mac-addr | all
Defaults: The permitted vendor list is empty by default and all vendors are allowed.
Access: Enabled.
Usage: The permitted vendor list applies only to the switch on which the list is
configured. Switches do not share permitted vendor lists.
Examples: The following command adds an entry for clients whose MAC addresses start
DWS-1008# set rfdetect vendor-list client aa:bb:cc:00:00:00
success: MAC aa:bb:cc:00:00:00 is now in client vendor-list.
The trailing 00:00:00 value is required.
show rfdetect attack-list
Displays information about the MAC addresses in the attack list.
Syntax: show rfdetect attack-list
Defaults: None.
Access: Enabled.
Examples: The following example shows the attack list on switch:
DWS-1008# show rfdetect attack-list
Total number of entries: 1
Attacklist MAC
------------------------ -----------------------
11:22:33:44:55:66 dap 2/1/11
show rfdetect black-list
Displays information abut the clients in the client black list.
Syntax: show rfdetect black-list
Defaults: None.
Access: Enabled.
Examples: The following example shows the client black list on switch:
DWS-1008# show rfdetect black-list
D-Link Systems, Inc.
Specifies whether the entry is for an AP brand or
a client brand.
Organizationally Unique Identifier (OUI) to
remove.
However, after you add an entry to the list, MSS allows only the devices whose
OUIs are on the list.
with aa:bb:cc:
Port/Radio/Chan RSSI SSID
------- ---------------
-53 rogue-ssid
RF Detection Commands
341