Set Igmp Qri - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
vlan vlan-id VLAN name or number. If you do not specify a
Defaults: The default query interval is 125 seconds.
Access: Enabled.
Usage: The query interval is applicable only when the switch is querier for the
subnet. For the switch to become the querier, the pseudo-querier feature
must be enabled on the switch and the switch must have the lowest IP address
among all the devices eligible to become a querier. To enable the pseudo-
querier feature, use the set igmp querier command.
Examples: The following command changes the query interval on VLAN orange to 100
DWS-1008# set igmp qi 100 vlan orange
success: change accepted.

set igmp qri

Changes the IGMP query response interval timer on one VLAN or all VLANs on a switch.
Syntax: set igmp qri tenth-seconds [vlan vlan-id]
qri
tenth-seconds
vlan vlan-id
Defaults: The default query response interval is 100 tenths of a second (10 seconds).
Access: Enabled.
Usage: The query response interval is applicable only when the switch is querier
for the subnet. For the switch to become the querier, the pseudo-querier
feature must be enabled on the switch and the switch must have the
lowest IP address among all the devices eligible to become a querier. To enable
the pseudo-querier feature, use set igmp querier.
Examples: The following command changes the query response interval on VLAN
DWS-1008# set igmp qri 50 vlan orange
success: change accepted.
D-Link Systems, Inc.
VLAN, the timer change applies to all VLANs.
seconds:
Amount of time (in tenths of a second) that
the switch waits for a receiver to respond to a
group-specific query message before removing
the receiver from the receiver list for the group.
You can specify a value from 1 through 65,535.
VLAN name or number. If you do not specify a
VLAN, the timer change applies to all VLANs.
orange to 50 tenths of a second (5 seconds):
IGMP Snooping Commands
257