D-Link DWS-1008 Cli Reference Manual page 170

DWS-1008 CLI Reference Guide
DWS-1008# set dap 1 bias low
success: change accepted.
set {ap | dap} blink
Enables or disables LED blink mode on a DWL-8220AP access point to make it easy to
identify. When blink mode is enabled on DWL-8220AP-xxx models, the health and radio
LEDs alternately blink green and amber. When blink mode is enabled on an AP2750, the
11a LED blinks on and off. By default, blink mode is disabled.
Syntax
ap port-list
dap dap-num
dapauto
enable
disable
Defaults:
Usage:
Examples:
DWS-1008# set ap 3-4 blink enable
success: change accepted.
D-Link Systems, Inc.
For example, if an DWL-8220AP is dual homed to two DWS-1008 switches,
and one of the switches has 50 active DWL-8220APs while the other switch
has 60 active DWL-8220APs, the new DWL-8220AP selects the switch that
has only 50 active DWL-8220APs. If the boot request on DWL-8220AP port 1
fails, the DWL-8220AP attempts to boot over its port 2, using the same
process described above.
DWL-8220AP selection of a DWS-1008 switch is sticky. After an DWL-8220AP
selects a switch to boot from, the DWL-8220AP continues to use that switch
for its active data link even if another switch configured with high bias for the
DWL-8220AP becomes available.
The following command changes the bias for a Distributed AP to low:
set {ap port-list | dap {dap-num | auto}} blink {enable | disable}
List of ports connected to the DWL-8220AP access points on which to
turn blink mode on or off.
Number of a Distributed AP on which to turn blink mode on or off.
Configures blink mode for the DWL-8220AP configuration template.
Enables blink mode.
Disables blink mode.
LED blink mode is disabled by default.
Changing the LED blink mode does not alter operation of the DWL-8220AP
access point. Only the behavior of the LEDs is affected.
The following command enables LED blink mode on the DWL-8220AP
access points connected to ports 3 and 4:
Access Point Commands
169