D-Link DWS-1008 Cli Reference Manual page 32

DWS-1008 CLI Reference Guide
set dap (continued)
Syntax: set dap dap-num serial-id serial-ID model {dwl-8220ap}
[radiotype {11a | 11b| 11g}]
dap-num
serial-id serial-ID
radiotype 11a|11b|11g
Defaults: The default radio type for the DWL-8220AP is 802.11g. AP radios configured for
802.11g also allow associations from 802.11b clients by default. To disable support
for 802.11b associations, use the set radio-profile 11g-only command on the
radio profile that contains the radio.
The DWL-8220AP has an internal 802.1b/g antenna as well as a connector for an
external antenna, so use of an external antenna is optional on these models. It also has a
connector for an optional external 802.11a antenna. To specify the antenna model, use the
set {ap |dap} radio antennatype command.
Access: Enabled
Examples: The following command configures Distributed AP 1 for a DWL-8220AP with
serial-ID 0322199999:
DWS-1008# set dap 1 serial-id 0322199999 model dwl-8220ap
success: change accepted.
The following command removes Distributed AP 1:
DWS-1008# clear dap 1
This will clear specified DAP devices. Would you like to continue? (y/n)
[n]y
D-Link Systems, Inc.
Number for the Distributed AP.
DWL-8220AP access point serial ID. The serial ID is
listed on the AP case. To display the serial ID using the
CLI, use the show version details command. The range
of valid connection numbers is from 1-30.
Radio type:
• 11a—802.11a
• 11b—802.11b
• 11g—802.11g
Port Commands
31