Clear Radius Proxy Client; Clear Radius Proxy Port - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
DWS-1008# clear radius retransmit
success: change accepted.
DWS-1008# clear radius timeout
success: change accepted.
clear radius client system-ip
Removes the switch's system IP address from use as the permanent source address in
RADIUS client requests from the switch to its RADIUS server(s).
Syntax:
Defaults:
Access:
Usage: The clear radius client system-ip command causes the switch to use the IP
address of the interface through which it sends a RADIUS client request as the source
IP address. The switch selects a source interface address based on information in
its routing table as the source address for RADIUS packets leaving the switch.
Examples: To clear the system IP address as the permanent source address for RADIUS
DWS-1008# clear radius client system-ip
success: change accepted.

clear radius proxy client

Removes a RADIUS proxy client entry for a third-party AP.
Syntax:
Defaults:
Access:
Examples: The following command clears all RADIUS proxy client entries from the switch:
DWS-1008# clear radius proxy client all
success: change accepted.

clear radius proxy port

Removes a RADIUS proxy port configured for a third-party AP.
D-Link Systems, Inc.
clear radius client system-ip
None.
Enabled.
client requests, type the following command:
clear radius proxy client all
None.
Enabled.
RADIUS Commands
302