D-Link DWS-1008 Cli Reference Manual page 203

DWS-1008 CLI Reference Guide
set service-profile tkip-mc-time
Changes the length of time that DWL-8220AP radios use countermeasures if two message
integrity code (MIC) failures occur within 60 seconds. When countermeasures are in effect,
DWL-8220AP radios dissociate all TKIP and WPA WEP clients and refuse all association
and reassociation requests until the countermeasures end.
Syntax:
name
wait-time
Defaults:
Access:
Usage:
not affected. The TKIP cipher suite must be enabled. The WPA IE also must
be enabled.
Examples:
DWS-1008# set service-profile sp3 tkip-mc-time 30000
success: change accepted.
set service-profile wep active-multicast-index
Specifies the static Wired-Equivalent Privacy (WEP) key (one of four) to use for encrypting
multicast frames.
Syntax:
name
num
Defaults:
Access:
Usage:
D-Link Systems, Inc.
set service-profile name tkip-mc-time wait-time
Service profile name.
Number of milliseconds (ms) countermeasures remain in effect. You can
specify from 0 to 60,000.
The default countermeasures wait time is 60,000 ms (60 seconds).
Enabled
Countermeasures apply only to TKIP and WEP clients. This includes WPA
WEP clients and non-WPA WEP clients. CCMP clients are
The following command changes the countermeasures wait time for service
profile sp3 to 30,000 ms (30 seconds):
set service-profile name wep active-multicast-index num
Service profile name.
WEP key number. You can enter a value from 1 through 4.
If WEP encryption is enabled and WEP keys are defined, DWL-8220AP
radios use WEP key 1 to encrypt multicast frames, by default.
Enabled
Before using this command, you must configure values for the WEP keys you
plan to use. Use the set service-profile wep key-index command.
Access Point Commands
202