D-Link DWS-1008 Cli Reference Manual page 316

DWS-1008 CLI Reference Guide
Access:
Usage:
Examples:
DWS-1008# set dot1x authcontrol enable
success: dot1x authcontrol enabled.
set dot1x bonded-period
Changes the Bonded Auth™ (bonded authentication) period. The Bonded Auth period is
the number of seconds MSS allows a Bonded Auth user to reauthenticate.
Syntax:
seconds
Defaults:
Access:
Usage:
D-Link recommends that you try 60 seconds, and change the period to a longer value only if
clients are unable to authenticate within 60 seconds.
The bonded authentication period applies only to 802.1X authentication rules that contain
the bonded option.
Examples:
DWS-1008# set dot1x bonded-period 60
success: change accepted.
D-Link Systems, Inc.
Enabled.
This command applies only to wired authentication ports.
To enable per-port 802.1X authentication on wired authentication ports, type
the following command:
set dot1x bonded-period seconds
Number of seconds MSS retains session
information for an authenticated machine while
waiting for a client to (re)authenticate on the
same machine. You can change the bonded
authentication period to a value from 1 to 300
seconds.
The default bonded period is 0 seconds, which disables the feature.
Enabled.
Normally, the Bonded Auth period needs to be set only if the network has
Bonded Auth clients that use dynamic WEP, or use WEP-40 or WEP-104
encryption with WPA or RSN. These clients can be affected by the 802.1X
reauthentication parameter or the RADIUS Session-Timeout parameter.
To set the bonded authentication period to 60 seconds, type the following
command:
802.1x Management Commands
315