Set Port - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide

set port

Administratively disables or reenables a port.
Syntax: set port {enable | disable} port-list
enable
disable
port-list
Defaults: All ports are enabled.
Access: Enabled
Usage: A port that is administratively disabled cannot send or receive packets.This command
does not affect the link state of the port.
Examples: The following command disables port 16:
DWS-1008# set port disable 16
success: set "disable" on port 16
The fol1owing command reenables the port:
DWS-1008# set port enable 16
success: set "enable" on port 16
set port-group
Configures a load-sharing port group. All ports in the group function as a single logical link.
Syntax: set port-group name group-name port-list mode {on | off}
name group-name Alphanumeric string of up to 255 characters, with no spaces.
port-list
mode {on | off}
Defaults: Once configured, a group is enabled by default.
Access: Enabled
D-Link Systems, Inc.
Enables the specified ports.
Disables the specified ports.
List of physical ports. MSS disables or reenables all the specified ports.
List of physical ports. All the ports you specify are configured together
as a single logical link.
State of the group. Use on to enable the group or off to disable the
group. The group is enabled by default.
Port Commands
32