D-Link DWS-1008 Cli Reference Manual page 317

DWS-1008 CLI Reference Guide
set dot1x key-tx
Enables or disables the transmission of encryption key information to the supplicant (client)
in EAP over LAN (EAPoL) key messages, after authentication is successful.
Syntax:
enable
disable
Defaults:
Access:
Examples:
DWS-1008# set dot1x key-tx enable
success: dot1x key transmission enabled.
set dot1x max-req
Sets the maximum number of times the switch retransmits an EAP request to a supplicant
(client) before ending the authentication session.
Syntax:
number-of-retransmissions Specify a value between 0 and 10.
Defaults:
Access:
Usage:
Examples:
DWS-1008# set dot1x max-req 3
success: dot1x max request set to 3.
D-Link Systems, Inc.
set dot1x key-tx {enable | disable}
Enables transmission of encryption key
information to clients.
Disables transmission of encryption key
information to clients.
Key transmission is enabled by default.
Enabled.
Type the following command to enable key transmission:
set dot1x max-req number-of-retransmissions
The default number of EAP retransmissions is 2.
Enabled.
To support SSIDs that have both 802.1X and static WEP clients, MSS sends
a maximum of two ID requests, even if this parameter is set to a higher value.
Setting the parameter to a higher value does affect all other types of EAP
messages.
Type the following command to set the maximum number of EAP request
retransmissions to three attempts:
802.1x Management Commands
316