D-Link DWS-1008 Cli Reference Manual page 353

DWS-1008 CLI Reference Guide
The backup command places the boot configuration file into the archive. (The boot
configuration file is the Configured boot configuration in the show boot command's output.)
If the running configuration contains changes that have not been saved, these changes are
not in the boot configuration file and are not archived. To make sure the archive contains the
configuration that is currently running on the switch, use the save config command to save
the running configuration to the boot configuration file, before using the backup command.
Examples:
DWS-1008# backup system tftp:/10.10.20.9/sysa_bak critical
success: sent 28263 bytes in 0.324 seconds [ 87231 bytes/sec]
clear boot config
Resets to the factory default the configuration that MSS loads during a reboot.
Syntax: clear boot config
Defaults: None.
Access: Enabled.
Examples: The following commands back up the configuration file on a switch, reset the
DWS-1008# copy configuration tftp://10.1.1.1/backupcfg
success: sent 365 bytes in 0.401 seconds [ 910 bytes/sec]
DWS-1008# clear boot config
success: Reset boot config to factory defaults.
DWS-1008# reset system force
...... rebooting ......
copy
Performs the following copy operations:
• Copies a file from a TFTP server to nonvolatile storage.
• Copies a file from nonvolatile storage or temporary storage to a TFTP server.
• Copies a file from one area in nonvolatile storage to another.
•
Copies a file to a new filename in nonvolatile storage.
D-Link Systems, Inc.
The following command creates an archive of the system-critical files and
copies the archive directly to a TFTP server. The filename in this example
includes a TFTP server IP address, so the archive is not stored locally on the
switch.
switch to its factory default configuration, and reboot the switch:
File Management Commands
352