D-Link DWS-1008 Cli Reference Manual page 165

DWS-1008 CLI Reference Guide
Examples:
DWS-1008# clear ap 3 radio 2
clear radio-profile
Removes a radio profile or resets one of the profile's parameters to its default value.
Syntax: clear radio-profile name [parameter]
name
parameter
Defaults:
Access:
Usage:
Examples:
DWS-1008# set radio-profile rp1 mode disable
DWS-1008# clear radio-profile rp1 beacon-interval
success: change accepted.
D-Link Systems, Inc.
The following command disables and resets radio 2 on the DWL-8220AP
access point connected to port 3:
Radio profile name.
Radio profile parameter:
• beacon-interval
• dtim-interval
• frag-threshold
• long-retry
• max-rx-lifetime
• max-tx-lifetime
• preamble-length
• rts-threshold
• service-profile
• short-retry
(For information about these parameters, see the set radio-profile
commands that use them.)
If you reset an individual parameter, the parameter is returned to the default
value.
Enabled.
If you specify a parameter, the setting for the parameter is reset to its default
value. The settings of the other parameters are unchanged and the radio profile
remains in the configuration. If you do not specify a parameter, the entire
radio profile is deleted from the configuration. All radios that use this profile
must be disabled before you can delete the profile.
The following commands disable the radios that are using radio profile rp1
and reset the beaconed-interval parameter to its default value:
Access Point Commands
164