D-Link DWS-1008 Cli Reference Manual page 89

DWS-1008 CLI Reference Guide
set snmp usm (continued)
usm-username
snmp-engine-id {ip ip-addr
| local | hex hex-string}
access {read-only | read-notify Specifies the access level of the user:
| notify-only | read-write |
notify-read-write}
D-Link Systems, Inc.
Name of the SNMPv3 user. Specify between 1 and 32
alphanumeric characters, with no spaces.
Specifies a unique identifier for the SNMP engine.
To send informs, you must specify the engine ID of the
inform receiver.
To send traps and to allow get and set operations and so
on, specify local as the engine ID.
• hex hex-string - ID is a hexadecimal string.
• ip ip-addr - ID is based on the IP address of the
station running the management application.
Enter the IP address of the station. MSS calculates
the engine ID based on the address.
• local - Uses the value computed from the
switch's system IP address.
• read-only - An SNMP management application
using the string can get (read) object values on
the switch but cannot set (write) them.
• read-notify - An SNMP management application
using the string can get object values on the
switch but cannot set them. The switch can use
the string to send notifications.
• notify-only - The switch can use the string to
send notifications.
• read-write - An SNMP management application
using the string can get and set object values on
the switch.
• notify-read-write - An SNMP management
application using the string can get and set
object values on the switch. The switch can use
the string to send notifications.
IP Services Commands
88