Show Port Status - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
Examples: The following command displays PoE information for all ports on the DWS-1008
switch:
DWS-1008# show port poe
Port Name
=============================================================
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
The table below describes the fields in this display.
Field
Port
Name
Link status
Port type
PoE config
PoE Draw

show port status

Displays configuration and status information for ports.
Syntax: show port status [port-list]
port-list
Defaults: None
D-Link Systems, Inc.
Link Port
Status Type
up
down
down
down
down
up
down
down
Port number.
Port name. If the port does not have a name, the port number is listed.
Link status of the port:
• up - The port is connected.
• down - The port is not connected.
Port type:
• MP - The port is an AP access port.
• - (The port is not an AP access port.)
PoE state:
• enabled
• disabled
Power draw on the port, in watts. For 10/100 Ethernet ports on which
PoE is disabled, this field displays off. For gigabit Ethernet ports, this
field displays invalid, because PoE is not supported on gigabit Ethernet
ports. The value overcurrent indicates a PoE problem such as a short
in the cable.
List of physical ports. If you do not specify a port list, information is displayed
for all ports.
PoE
config
- disabled
- disabled
- disabled
- disabled
- disabled
MP enabled
- disabled
- disabled
Description
Port Commands
PoE
Draw
off
off
off
off
off
1.44
invalid
invalid
42