Set Port Name - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
set port-group
Usage:You can configure up to 16 ports in a port group, in any combination of ports. The port
numbers do not need to be contiguous and you can use 10/100 Ethernet ports and gigabit
Ethernet ports in the same port group. After you add a port to a port group, you cannot
configure port parameters on the individual port. Instead, change port parameters on the
entire group. Specify the group name instead of an individual port name or number in port
configuration commands.
To add or remove ports in a group that is already configured, change the mode to off, add or
remove the ports, then change the mode to on.
Examples: The following command configures a port group named server1 containing ports
DWS-1008# set port-group name server1 1-5 mode on
success: change accepted.
The following commands disable the link for port group server1, change the list of ports in
the group, and reenable the link:
DWS-1008# set port-group name server1 1-5 mode off
success: change accepted.
DWS-1008# set port-group name server1 1-4,7 mode on
success: change accepted.

set port name

Assigns a name to a port. After naming a port, you can use the port name or number in other
CLI commands.
Syntax: set port port name name
port
name name Alphanumeric string of up to 16 characters, with no spaces.
Defaults: None
Usage: To simplify configuration and avoid confusion between a port's number and its name,
D-Link recommends that you do not use numbers as port names.
Examples: The following command sets the name of port 5 to adminpool:
DWS-1008# set port 5 name adminpool
success: change accepted.
D-Link Systems, Inc.
1 through 5, and enables the link:
Number of a physical port. You can specify only one port.
Access: Enabled
Port Commands
33