Set Snoop Mode - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
Access: Enabled.
Usage: You can map the same filter to more than one radio. You can map up to eight filters
to the same radio. If more than one filter has the same observer, the AP sends only one
copy of a packet that matches a filter to the observer. After the first match, the AP sends the
packet and stops comparing the packet against other filters for the same observer.
If the filter does not have an observer, the AP still maintains a counter of the number of packets
that match the filter.
Examples: The following command maps snoop filter snoop1 to radio 2 on Distributed AP3:
DWS-1008# set snoop map snoop1 dap 3 radio 2
success: change accepted.

set snoop mode

Enables a snoop filter. A snoop filter does not take effect until you map it to an AP radio and
enable the filter.
Examples: set snoop {filter-name | all}
mode {enable [stop-after num-pkts] | disable}
filter-name | all}
enable
[stop-after num-pkts]
disable
Defaults: Snoop filters are disabled by default.
Access: Enabled.
Usage: The filter mode is not retained if you change the filter configuration or disable and
reenable the radio, or when the AP or the switch is restarted. You must reenable
the filter to place it back into effect.
Examples: The following command enables snoop filter snoop1, and configures the filter to
stop after 5000 packets match the filter:
DWS-1008# set snoop snoop1 mode enable stop-after 5000
success: filter 'snoop1' enabled
D-Link Systems, Inc.
Name of the snoop filter. Specify all to
enable all snoop filters.
Enables the snoop filter.
The stop-after option disables the filter
after the specified number of packets
match the filter. Without the stop-after
option, the filter operates until you disable
it or until the AP is restarted.
Disables the snoop filter.
Snoop Commands
376