D-Link DWS-1008 Cli Reference Manual page 15

DWS-1008 CLI Reference Guide
help
Displays a list of commands that can be used to configure and monitor the switch.
Syntax: help
Defaults: None.
Access: All.
Examples: Use this command to see a list of available commands. If you have restricted
DWS-1008# help
Commands:
-------------------------------------------------------------------------------------------------
backup
clear
commit
copy
crypto
delete
dir
disable
disable
help
history
hit-sample-rate
load
logout
md5
mkdir
monitor
ping
quickstart
quit
reset
restore
rmdir
rollback
save
set
show
telnet
test
traceroute
validate
D-Link Systems, Inc.
access, you see fewer commands than if you have enabled access. To display
a list of CLI commands available at the enabled access level, type the following
command at the enabled access level:
Backup system information to filename (or url)
Clear aaa accounting parameters
Commit the content of the ACL table
Copy from filename (or url) to filename (or url)
Incorporate a signed certificate
Delete url
Show list of files on flash device
Disable privileged mode
Disable privileged mode
Show this help screen
Show contents of history substitution buffer
Set NP hit-counter sample rate
load configuration from persistent storage
Exit from the Admin session
md5 filename
Create a subdirectory on flash device
monitor port counters statistics
Send echo packets to hosts
Perform an initial configuration
Exit from the Admin session
reset ap
Restore system information from filename (or url)
Remove a subdirectory created by mkdir
Remove changes to the edited ACL table
Save the running configuration to persistent storage
Set aaa debugging
Show aaa information
telnet ip address [server port]
Test AAA
Print the route packets take to network host
validate action functions
System Services Commands
14